|Quick Find Code||007720|
Stir adhesive well before use. (DO NOT USE BELOW 10°C)
The adhesive is applied to both surfaces in a thin coat using a short stiff brush or spreader. When the surfaces become “touch dry” (ie adhesive is glossy and no longer transfers to the knuckles) for between 10 and 20 minutes. Porous surfaces must receive two coats allowing the adhesive to dry coats. Align the bond edges and bond under maximum pressure. For best results, laminates should be nip rolled or pressed. If this is not possible, use a hard roller and go over the entire surface using as much bodyweight as possible, working from the centre outwards. Seams and edges should also receive extra pressure.
The newly bonded material should not be subjected to extreme temperature changes for 3 to 4 days after bonding. Avoid further fabrication until the adhesive has fully cured.
|Country of Manufacture||United Kingdom|